WTT Hifonics 2610D for smaller amp

Boomsday
10+ year member

CarAudio.com Veteran
4,005
3
My House
Downgrading a bit, looking to do a straight trade for an amp that does about 1500rms@1ohm +cash, or +box build (just 2.5cuft), works 100% the lights just do not glow blue anymore...Functionally its 10/10 Cosmetically its 8/10

DSC03975.jpg


DSC03977.jpg


DSC03979.jpg


DSC03980.jpg


specs

* RMS Power Output: 1 x 850 W @ 4 Ohms

* RMS Power Output: 1 x 1700 W @ 2 Ohms

* RMS Power Output: 1 x 2600 W @ 1 Ohm

* Slow Un-Mute Turn-On (soft start)

* Protection: DC, Speaker Short, Thermal, Overload

* Power Supply MOSFET

* Audio Output MOSFET

* Dampening Factor: >250

* Signal To Noise Ratio (A-weighted): >95dB

* Variable Input Level Control (unbalanced): 0.2V - 9V

* Input Level Control (balanced): 0.04V - 18V

* Input Impedance (un-balanced): 47k-Ohm

* Input Impedance (balanced): 20k-Ohm

* Power / Diagnostic L.E.D.

* Variable Low Pass Filter / 24dB: 35Hz - 250Hz

* Variable Subsonic Filter / 24dB: 15Hz - 35Hz

* Variable Bass EQ: 0dB - +10dB

* Phase Shift (0 - +180 degrees)

* Unbalanced Inputs (RCA)

* Balanced Inputs (DIN)

* Line Output (RCA)

* Speaker Terminals (molded): 12ga

* Power/Ground Terminals (molded): 0ga

* Remote Bass Module: HFR-3

* Parametric bass EQ with 45Hz bass boost and variable control from 0db to 10db

* Variable Low Pass, Subsonic Filter, Phase Shift and Level Control

* Balanced line input for MX accessories and line drivers

* Bass Remote included

* Built-In System Diagnostics protects from short circuits, over load, thermal overheat and DC Offset.

* Link & Sync™ feature allows the mono amps to be strapped or bridged via master/slave configuration

* Dimensions 17.72" x 2.52" x 9.45"

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yep, at the amplifiers. I get the same 14.7 volt reading when they cutoff too.
12
1K
Pull it and test it at the battery post. Simple Power up test to verify if it powers up fine out of protect mode. if it does then Id be checking...
3
1K
I have a Gemeni VII, Heucules VII, Pluto VII, and a Vulcan VII left out of a massive slew of VII and VIII series. They still work Excellent...
5
3K
  • Locked
COMPLETED Hifonics Plato III
Yes, they are painted. The cover is very easy to take off and repaint to whatever color of choice to match the install.
2
1K

About this thread

Boomsday

10+ year member
CarAudio.com Veteran
Thread starter
Boomsday
Joined
Location
My House
Start date
Participants
Who Replied
Replies
29
Views
1,458
Last reply date
Last reply from
d77543020
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0
Screenshot 2024-05-31 182324.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top