Wiring question

[billjones42 10+ year member]

Ok. I have a PPI PCX-480 and a RE SE 10 D4. Will I have any problems if I wire the amp into 2 channel bridged mode(320 x 2 at 4ohm) and wire one channel to each coil?

Click to read more...

 

[billjones42 10+ year member]

anyone?

 

[billjones42 10+ year member]

nobody??

 

[billjones42 10+ year member]

hello?

 

[billjones42 10+ year member]

anyone?

 

[billjones42 10+ year member]

somebody?

 

[billjones42 10+ year member]

help?

 

[billjones42 10+ year member]

really?

 

[Dr. Hertz 10+ year member]

You will not have definite problems. wiring subs like that will require a multi-meter to level set each channel to the same output. I am not going to explain it here how to do it, but I'm sure you can find how to do that on this site, or on the12volt.com. Using a higher qua;ity amp is always recommended when running different channels/amps to the same sub, and your PPI is a decent option to do this, which is very possible. I've run an amp to each coil W/O issue, just be sure the levels are even.