Wiring done write but to connect to 1ohm, but no sound

[Jayy 10+ year member]

so i have dual 4 ohm subs wired - to - and + to + for both sides and connected 2 - wires to 1 - and 2 + wires to 1 +, but yet no sound?

Click to read more...

 

[mast240 10+ year member]

ok.... trying to figure out what your saying here... are you saying that u have them wired parralel, all positive together, and negatives together?

what amp you running? electrical? subs?

 

[Jayy 10+ year member]

Hifonics brutus 1200 80 Amp, 6 gauge power and 6 gauge ground came with a 65 amp fuse but just put in a 80 amp fuse, and there dual sundown SA-10's. It says it need 4 gauge but i trryed it with 6

http://www.caraudiodeals.com/hifonics-bxi2010d-p-1981.html

 

[mast240 10+ year member]

i'm thinking you got a wire hooked up wrong... faulty ground, bad remote, bad power... tripple check all

 

[hispls 5,000+ posts]

Hifonics brutus 1200 80 Amp, 6 gauge power and 6 gauge ground came with a 65 amp fuse but just put in a 80 amp fuse, and there dual sundown SA-10's. It says it need 4 gauge but i trryed it with 6
Hifonics Car Audio Brutus BXi 2010D Mono Block Car Amplifier 2000 Watts RMS (BXi2010D)

Why over-fuse? If you can't get the amp to play at all, it's not like you keep blowing fuses and need to step up?

 

[mast240 10+ year member]

well... whats the amp rated at for the fuse? thats what you want to have it fused at... no more, no less

 

[pushak513 10+ year member]

basically the same problem I am having the dual 4 wire em up to em to the amp and no sound.

 

[Jayy 10+ year member]

the wire i have is 80 amp fuse, and the amp is 80 amp fuse

 

[mast240 10+ year member]

ok... well then your fuse should be proper..

99% of the time, with new subs... when you run into this problem, its either a bad ground, remote, or power (usually in that order)

 

[Jayy 10+ year member]

ok, i will get that checked