which 6.5 comps for this amp?

[DejaWiz 5,000+ posts]

Man, you should have one nice system for the money spent!

 

[kross 10+ year member]

BTW I'll check the prices on 1/0 gauge and see if I can afford it, after buying those 3 things I'm pretty much broke right now

Check ebay for Kicker PKD1 wiring kits. It's a dual-amp kit, it includes 1/0 gauge wire, a distro block, and some 4 gauge wire to go to the amps from the distro block. Plus a few extra goodies, too. It can be had for around $90 shipped, I believe.

 

[rmdl51 10+ year member]

Ok, Here I come again...

I just receive the Hifonics and I noticed that it has 4 teminals (-)(-)(+)(+) but it's single channel right? if I'm plugging my CVR's at 1 ohm which their DVC are already in parallel, should I merge both wires and use a single (+) (-) from the amp? or is it true that it's internally bridged and it has two set of terminals for convenience to avoid merging the subs cables and then I'm able to connect each sub to it's own terminal and still be 1 ohm? My purpose is to give them 600w RMS.

Ok about the cables now, I'm pretty much done buying stuff, I just need to buy the power wires and distro block, the kicker kit you suggest before contents:

20 ft. - 1/2 AWG Power Cable (is this one ok? I though you suggest 1/0)

3 ft. - 1/0 AWG Ground Cable (here I got lost why ground is diff?)

5 ft. - 4 AWG extra Power Cable (is this ok to run from distro to amps?)

5 ft. - 4 AWG extra Ground Cable (I think this is also for the amp to distro)

2 Power Distribution Blocks (DB 1448)

Fuse Holder (FHMA)

300A ANL Fuse (what is this fuse for? the one for batt terminal? too big right? you suggest 125A)

Ok, Thanks for the help

 

[rmdl51 10+ year member]

Try to find a Class D mono amp that is 1 ohm stable at around 600-800w rms for those subs. (each wired in parallel = 2 ohms each, then both wired in parallel = 1 ohm at the amp)
Something like a Hifonics BXi606D or similar.

after some searching I think I understand pretty much everything on the cables, I dont want to start a new thread for this question, I know I've been off the main topic but I hope you can help me with this one.

I'm confused about wiring the CVR's at 1 ohm, according to your saying I believe they should be wiring in one of these ways, but I'm not sure which is the correct one:

View attachment 11375

View attachment 11376

View attachment 11377

Besides I found this equation diagram on the forum which I think (if I'm doing the math ok) the setup in any of these ways will be 4 ohm

View attachment 11378

Can someone clear up this for me please?

Thank you!

 

[DejaWiz 5,000+ posts]

It really doesn't matter much.

However, I say middle diagram. But use the left + and - for one sub and the right + and - for the other.

(+) (+) (-) (-)

L+ R+ L- R-

 

[rmdl51 10+ year member]

Ok! I Got it! so, this will be 1 ohm as you said before? I just want to get the best performance out of my new setup, and I believe that's 600w rms @ 1ohm correct?

 

[DejaWiz 5,000+ posts]

Correct sir!