Reply to thread

Message

<blockquote data-quote="rmdl51" data-source="post: 3284124" data-attributes="member: 570288">Ok, Here I come again...I just receive the Hifonics and I noticed that it has 4 teminals (-)(-)(+)(+) but it&#039;s single channel right? if I&#039;m plugging my CVR&#039;s at 1 ohm which their DVC are already in parallel, should I merge both wires and use a single (+) (-) from the amp? or is it true that it&#039;s internally bridged and it has two set of terminals for convenience to avoid merging the subs cables and then I&#039;m able to connect each sub to it&#039;s own terminal and still be 1 ohm? My purpose is to give them 600w RMS.Ok about the cables now, I&#039;m pretty much done buying stuff, I just need to buy the power wires and distro block, the kicker kit you suggest before contents:20 ft. - 1/2 AWG Power Cable (is this one ok? I though you suggest 1/0)3 ft. - 1/0 AWG Ground Cable&nbsp; (here I got lost why ground is diff?)5 ft. - 4 AWG extra Power Cable (is this ok to run from distro to amps?)5 ft. - 4 AWG extra Ground Cable (I think this is also for the amp to distro)2 Power Distribution Blocks (DB 1448)Fuse Holder (FHMA)300A ANL Fuse (what is this fuse for? the one for batt terminal? too big right? you suggest 125A)Ok, Thanks for the help</blockquote>

[QUOTE="rmdl51, post: 3284124, member: 570288"] Ok, Here I come again... I just receive the Hifonics and I noticed that it has 4 teminals (-)(-)(+)(+) but it's single channel right? if I'm plugging my CVR's at 1 ohm which their DVC are already in parallel, should I merge both wires and use a single (+) (-) from the amp? or is it true that it's internally bridged and it has two set of terminals for convenience to avoid merging the subs cables and then I'm able to connect each sub to it's own terminal and still be 1 ohm? My purpose is to give them 600w RMS. Ok about the cables now, I'm pretty much done buying stuff, I just need to buy the power wires and distro block, the kicker kit you suggest before contents: 20 ft. - 1/2 AWG Power Cable (is this one ok? I though you suggest 1/0) 3 ft. - 1/0 AWG Ground Cable (here I got lost why ground is diff?) 5 ft. - 4 AWG extra Power Cable (is this ok to run from distro to amps?) 5 ft. - 4 AWG extra Ground Cable (I think this is also for the amp to distro) 2 Power Distribution Blocks (DB 1448) Fuse Holder (FHMA) 300A ANL Fuse (what is this fuse for? the one for batt terminal? too big right? you suggest 125A) Ok, Thanks for the help [/QUOTE]

Verification