What Amp to get?

  • 2
    Participant count
  • Participant list

volvos40
10+ year member

Junior Member
I currently have 2 Polk Audio db521 speakers with a sony cdx-gt540ui receiver and polk audio dxi 124SVC. I'm look to power my sub with a mono amp or 2 channel amp, but I dont know which to pick from. My budget for the amp is up to $200. I am currently looking at the Kenwood Kac-9105D, Kenwood Excelon X1200M \RB and JL Audio JX360/2I need more suggestion please.

Also if allowed, can you recommend a sub enclosure, sealed or ported for my sub?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
51
You have a blown cap in the amp more than likely. Had the same thing happen to a soundstream amp.
1
71
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
250
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
458

About this thread

volvos40

10+ year member
Junior Member
Thread starter
volvos40
Joined
Location
United States
Start date
Participants
Who Replied
Replies
4
Views
977
Last reply date
Last reply from
volvos40
received_1404248310277849.jpeg

Blackout67

    Jun 10, 2024
  • 0
  • 0
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top