What mods do you have to the neon? What does it dyno at? Is this on street tire you did high 11s?
Hi Scrappy ....
If you look at my trap speed , compared to my ET , you will see that I spun through some of first and second gear . This is on drag radials , VHT , and a well prepped track ( oh the curse of front wheel drive cars ) .
I'll be switching to slicks this next summer , and also a set of pre loaded wheelie bars to help keep pressure on the front tires. I'll need to buy some 1000 hp axles first though.
I dyno at 460 to the front wheels , but can get 500 by using 2 oz of Nitro methane mixed with my gallon of 50/50 water mathanol injection , sprayed directly into the intake tract , both at the intercooler and throttle body.
Here's the mods list :
JMB Performance Ultimate 3" cold air intake w/ trunk mounted battery
Mopar Stage 0 computer
SAFC II piggyback
Dynoworks motor and transmission mounts
Blow By Catch Can
Mopar Stage III coilovers
All underhood ground and power wires replaced with 4 guage wire
AGP 8.5 mm spark plug wires
NGK plugs
Tial blow off valve
Mopar block off plate
Turbonetics Evolution Wastegate
Greddy Profec Type S boost controller
Breather mod and intake by-pass
BDJ Racing 3" O2 housing
BDJ Racing 3" side exit exhaust w/ Flo Pro Twister muffler
AGP Racing LARGE bar and plate, front mount intercooler
T Bolt Clamps on all pressure pipes
AGP Racing Return Fuel Kit w/rising rate fuel pressure regulator
Walbro 255 lpi fuel pump
Psi-Fi fuel pump re-wire for higher flow
Psi Fi complete vaccuum line delete and re-route
BDJ Racing hard up-pipe w/ custom flange
180 degree thermostat
Purple Ice coolant
Cold Air coilpack lift
Centerline Storm polished aluminum rims
225 x 45 / 17 Falken Azenis Sport tires
Mopar short throw shifter with Booger bushings
Custom Work shifter mounted , AUTOMATIC Hi / Lo boost level switch by gear
Mopar billet shift knob
Progress 27mm rear sway bar
Psi Fi control arm traction bushings
Redline Tuning hood risers
Amsoil 0W-30 Synthetic Race Oil and Transmission Fluid
Mopar door sill plates
AC Schnitzer M3 wing
Coolingmist water / methanol dual stage injection kit.
Custom shift light ( programable )
AGP 50 trim turbo and RC Racing 750cc injectors
BDJ Racing True 60mm throttle body w/ 60mm spacer
BDJ Racing ceramic coated, extrude honed, port matched, polished intake manifold
Centerforce dual friction stage 4 clutch