I went out to set my gain a few mins ago on a 2 channel amp to run my component speakers. I was setting them to 20 volts (100 watt rms) to a 1khz sine wave with the HU at the 3/4th mark. One channel would read right at 20...when I would check the other channel it would be around 18.6 Is this common? What would cause this issue?
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
The amp is only about a month and a half old but did run it couple too many times clipping and even saw the protect light flash a couple times I...
- Started by cfoote2424
- Wiring, Electrical & Installation
Anything made in the last ~10 years will have a "weasel" alternator.
- Started by some dude
- Wiring, Electrical & Installation
Yeah, put the probes on the power wire and ground wire of the amplifier. Multimeter on DC.
Do not put it on the wires that go to your speakers. M
- Started by Mr FaceCaser
- Amplifiers
It's still a very small company that is growing. And growing has its challenges. He is very active on Facebook and does plenty of real test...
- Started by Doxquzme
- General Car Audio
About this thread
New threads
-
-
What type and placement of box for dual 8 or 10" shallow depth subs for 2011 Hyundai Veracruz?
- Started by kanihoncho
- Replies: 4
-
-
-