Voltage question...

  • 2
    Participant count
  • Participant list

agarabaghi
10+ year member

Senior VIP Member
So my isolator broke, and now my aux battery is not charging. With the engine off and all the amps im reading 10.9-11.0v sitting. This could cause some issues with the amps and cause clipping right?

Im not running the stereo anymore, but i noticed my sub was cutting in an out, and then i realized the isolator was broken. One of the posts broke off and now it's set to always open (keeps both batteries separated).

Hopefully when the new isolator comes in, and i get the battery charged back up everything will go back to normal.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

The AudioControl LC7i has a maximum output voltage of up to 8.5volts. It can output up to 8.5 volts which is more than a typical aftermarket head...
1
804
Ok. I think I get it. There's really not much to be gained between charging them at say 60% and 100%. At least not on a daily system. Please...
13
2K
Yeah, put the probes on the power wire and ground wire of the amplifier. Multimeter on DC. Do not put it on the wires that go to your speakers. M
6
641

About this thread

agarabaghi

10+ year member
Senior VIP Member
Thread starter
agarabaghi
Joined
Location
Orlando, FL
Start date
Participants
Who Replied
Replies
4
Views
355
Last reply date
Last reply from
agarabaghi
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top