Two runs of 1/0 help.

[GhostMemphis 10+ year member]

Ok so tomorrow I am going to be doing my second run of shok 1/0 comp wire, it is going to a D2700 in the back. What I want to know is first off in everyones experience here do I even need a second run? I am using to audioque2200's strappedat 2 ohms and a cresendo 1000C4 (Iwant this to be a loud as possible and have as little voltage drop as possible). My second question is since I am running two powers will I need two grounds back to the front or to any blt in my trunk? Or do I even need two grounds.

Click to read more...

 

[BlactimusCrime 10+ year member]

i would do 2 ground runs from your back batt(s) to a good spot on the chassis. you always match the amount of ground to the amount of hot wire.

 

[matt_bennett05 10+ year member]

(Or just overkill and say "YEAH. I got 37 4/0 grounds. //content.invisioncic.com/y282845/emoticons/silly.gif.3549b64aaa5b6729eb8e865319a3234f.gif)

 

[GhostMemphis 10+ year member]

Lol I do have a 2/0 and 1/0 big three done.

So far one of my biggest challenges seem to be that the shok wire doesnt fit into my 1/0 ring terminals. I dont like to cut some away, but that is all I have been able to do. I don't want to buy 2/0 terminals because I already have 25 1/0 ones

 

[matt_bennett05 10+ year member]

Lol I do have a 2/0 and 1/0 big three done.
So far one of my biggest challenges seem to be that the shok wire doesnt fit into my 1/0 ring terminals. I dont like to cut some away, but that is all I have been able to do. I don't want to buy 2/0 terminals because I already have 25 1/0 ones

If you DON'T have to trim off but a very small amount it's not hurting anything (not enough that you would notice)