Hey I have a T1000.4 that I would like to use to power my whole system. I want to run a pair of components in the front and a single 12" ported in the back or possibly two tens. But my question is how should I wire the amp for best performance/reliability. In the manual it says if I want to run the amp in 2 channel mode I have to have the front speakers at 2ohm each and the rear woofer at 4 ohms. And in the 4 channel diagram the front speakers are both shown at 2ohm. Does this mean I need to buy speakers that are 2ohm like image dynamics, or can i run 4ohm speakers and not harm the amp? I can take a picture of the manual to show you guys what I mean if the above isn't clear.
