system idea

i told him this setup, and the reason i said the 2500, is because he wont have a strong electrical at the point of install most likely. (headroom on power, since he wont be able to have the amp at full tilt.)
or he could get the 2500D and just wire it at 4ohm load and be sitting around 1200W which would be nice and still not have the gain at full or near it //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
or he could get the 2500D and just wire it at 4ohm load and be sitting around 1200W which would be nice and still not have the gain at full or near it //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
u mean 2 ohm? (2500 at 1, 1200 at 2 i believe)

 
maybe it does, i was going by general rule of thumb. correct me if im wrong please
k ur wrong

Specifications:

2500D

$1599.99

2500

4 Ohm Rating 1200 x 1

2 Ohm Rating 1700 x 1

1 Ohm Rating 2500 x 1

Freq. Resp. 20Hz - 300Hz

THD+N

Damping factor > 50

Signal to noise ratio > 80

Crossover range/scope LP 30 - 250hz 12/24 db octave

Input sensitivity 200mV - 5V

Safe load impedance 1 ohm

Equalization Circuit Intelli Q 10 db

Remote level control Optional

Amplifier protection* T,D,R,S,O

Externally Bridgeable No

Dimensions** 27.2"L x 10.5"W x 2.3"H

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

sanmarcosZfreak

10+ year member
AE Installer
Thread starter
sanmarcosZfreak
Joined
Location
Kissimmee FL
Start date
Participants
Who Replied
Replies
15
Views
784
Last reply date
Last reply from
sanmarcosZfreak
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0
IMG_2118.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top