Sundown helpo.

[lilmaniac2 5,000+ posts]

I could be wrong, but that just looks like extra flux from the soldering, it looks to be mostly yellow, like the flux. Im still leaning toward install issue

 

[sqhertz 5,000+ posts]

I could be wrong, but that just looks like extra flux from the soldering, it looks to be mostly yellow, like the flux. Im still leaning toward install issue

im not 100% that its burnt. i didnt smell it or anything , i just noticed that looking over the components. as far as i know , the wires and cables in the car were fine as the x600.1 works perfect in there. all i did was swap em out. is there anything else i should do or look over before sending it in? //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

 

[lilmaniac2 5,000+ posts]

What Rca cables are you using, i know that there have been 1 or 2 issues that were caused by using the high end stinger cables

 

[sqhertz 5,000+ posts]

the truck has rockford fosgate twisted series rca's and the car has tiff? 2.0 , iirc. i probed the RF's with a dmm and they were putting out power. didnt probe the tiff's though as everything worked fine in there. i did not put the x600.1 in the truck though.

off to work.

 

[sundownz Pro Seller]

The little spot on the board looks like excess solder flux, that isn't anything.

I can take a look at it anyway, send it back to me per the instructions in the front cover of your manual.

 

[sqhertz 5,000+ posts]

The little spot on the board looks like excess solder flux, that isn't anything.
I can take a look at it anyway, send it back to me per the instructions in the front cover of your manual.

ill get it sent out tomorrow. do i need a RA# or anything? and if you find that it isnt a defect in the amp itself , would you contact me and give me a price on how much the repair would be? ill include my phone number.

 

[sqhertz 5,000+ posts]

ill get it sent out tomorrow. do i need a RA# or anything? and if you find that it isnt a defect in the amp itself , would you contact me and give me a price on how much the repair would be? ill include my phone number.

//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

 

[sundownz Pro Seller]

ill get it sent out tomorrow. do i need a RA# or anything? and if you find that it isnt a defect in the amp itself , would you contact me and give me a price on how much the repair would be? ill include my phone number.

Include your phone number, e-mail address, and you S/N on here so I know exactly who the amp came from. If a repair is needed outside of warranty I'll let you know, if it's defective it'll be taken care of under warranty.

 

[sqhertz 5,000+ posts]

Include your phone number, e-mail address, and you S/N on here so I know exactly who the amp came from. If a repair is needed outside of warranty I'll let you know, if it's defective it'll be taken care of under warranty.

its expected to get there this thursday , the 17th. thats the quickest ground shipment ive ever had , lol.