Briceyboy96
CarAudio.com Newbie
I currently have an auto tek mono amp which gives the following RMS power ratings
I also have a 2 ohm dvc 15” subwoofer ready to go that is currently wired down to 1ohm. My wiring is already ran from my previous setup and is 4 gauge.
my question is:
Would 4 gauge wiring be sufficient for 1250 watts into the sub or is it possible to allow the sub and amp to run at 2ohms? I know wiring in series would give the amp 4 ohms but the sub wouldn’t see enough power in that case.
Thanks!
- RMS Power Rating:
- 4 ohms: 313 watts x 1 chan.
- 2 ohms: 625 watts x 1 chan.
- 1 ohm: 1250 watts x 1 chan.
I also have a 2 ohm dvc 15” subwoofer ready to go that is currently wired down to 1ohm. My wiring is already ran from my previous setup and is 4 gauge.
my question is:
Would 4 gauge wiring be sufficient for 1250 watts into the sub or is it possible to allow the sub and amp to run at 2ohms? I know wiring in series would give the amp 4 ohms but the sub wouldn’t see enough power in that case.
Thanks!