Subs working barely. PLEASE HELP

[Wonderbread 5,000+ posts]

Ok, I'm going to assume that you have two single 4-ohm subwoofers. Look for an amplifier that will produce approximately 400-600 watts RMS (somewhere in the middle would be perfect) with a 2 ohm mono load. I'm not sure what kind of budget you're looking at however.

What about a Kicker KX600.1? Ikesound has them for 240 refurbed. Slightly less expensive is the Phoenix Gold x600.1 for 225, also from Ikesound.

These are just quick and dirty suggestions, I haven't been looking at amplifiers recently so I'm not really sure what all is out there. Find out the wiring configuration of your subwoofers. You might have dual 4 ohm subwoofers which means you have to look for an amp that will be stable at 1 ohm for 500 or so watts into one channel or an amp with similar output at 4 ohms, both of which will be likely to run you a few bucks more.

A little more information might help us out a little bit more.

 

[tzk0nlin3 10+ year member]

Also, Mono - 2channel - multichannel w/e those are which 1 do i need?

 

[imaspaceguy90 10+ year member]

since u have 2 subs just go 2 channel, it will be easier to wire.

 

[tzk0nlin3 10+ year member]

Well, Im not really worried about wiring, my dads a car dealership manager and has over 20 mechanics that work for him. So basically I can get someone else to do it if its hard. Also Im going to IM you on AIM imaspaceguy

 

[skadude016 5,000+ posts]

hey man! I'll ship you out my dragster amp for 100 shipped. Works great and will own that VR3 thing. I have a viper 1200.1 now so i dont really need my dragster amp.