Subs Broke Window Seal

Go to a glass shop and get some butyle rubber sealant or dow cornering 795. Silicone will produce rust and should never be used on bare metal. The dow 795 is what i would suggest as it stick to any surface and oddly enough is easy to clean off of a painted surface once it is dry by simply scraping with a finger nail. sounds wierd but regardless it holds better then anything. Or while there, ask what they suggest //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif (i used to have a glass shop btw http://www.cgiglass.com )

 
Are you shure the sub did it? I could care less, but Ive had windows leak on a 2 of my trucks with out subs.//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

 
man the same thing happened to my ranger after i dropped in the RE's and it was not my window check the seal on your third brake light mine was dryrotted so i replaced it with industrial glass adhesive blacke rubber junk and then trimmed with an exacto knife... the light was leaking and the water settled on top of the window in the gutter where the window is stamped out into the back of the cab. The water then appeared to leak around the window. I hope this is a quick fix for you if this is what happened.

 
Are you shure the sub did it? I could care less, but Ive had windows leak on a 2 of my trucks with out subs.//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif
Yea im pretty sure b/c it never leaked at all until i dropped the subs in..........no i just found out in the car wash today that it is leaking right onto me...from the door seal now......not from the window though...(i think i fixed it though)

 
Yea im pretty sure b/c it never leaked at all until i dropped the subs in..........no i just found out in the car wash today that it is leaking right onto me...from the door seal now......not from the window though...(i think i fixed it though)
**** like that happens sometimes...nice avatar btw //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 
My Ranger was blowing water in on the dash over the glovebox..

I was in cali so I would only see it like 2x a year..

but once it ran into the golve box & my Xover got wet //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

**** Fords..

232743_88_full.jpg


232743_82_full.jpg


 
that happened in my truck with 4 12's and 1600w, water leaked right on the amp and I heard a loud crack and I could see a small flame in the amp. Was probably my fault though I resealed it back in after being out for a bed cap. I got some butyl sealer and just filled in where it didnt look the best. Fine ever since

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

These are also very good drivers, some of the best bang for the busk on shallow mounts. DD Audio SL610-D2 10"...
5
111
Well, get Two then and try to share for peeks sake!! :poop: :ROFLMAO::ROFLMAO::ROFLMAO:
16
1K
Additinally, no need to reference "max" anything as those specs are useless. Most of know how to look at specs for a given speaker, amp, HU, etc...
2
419
If they had an orange basket I would have to buy them.... Hmmmm Sell my 4 Xs and get 6 of those and do no-wall again with one more 4500..... :unsure:
4
562
That’s the little single 6.5 inch enclosure. The Savard did just as well as the RDS. These subs do well in ported or 6th orders but not as well...
12
829

About this thread

drifterman33

10+ year member
Senior VIP Member
Thread starter
drifterman33
Joined
Location
Hell (aka Guerin)
Start date
Participants
Who Replied
Replies
13
Views
826
Last reply date
Last reply from
Lakota
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top