Sub Woofer Wiring Help

maxlaitinen93

Junior Member
6
0
Boston
Hello everyone - Just want to start by thanking anyone taking the time to read this.

I recently put an old Kenwood 12" 700w subwoofer I had from a few years ago into an enclosure and purchased a Dual DA6002D 600w amplifier. For a receiver I have a Boss BV760 Elite touchscreen head unit. I initially wired the amplifier to and Add-A-Fuse which was wired into the cabin fuse box. The subwoofer functioned for a total 5 minutes and cut out. None of the wires had come undone. Initially I assumed that maybe it was the add-a-fuse so I experimented wiring the amp directly to the battery, still nothing. I tested my girlfriends amp which would briefly turn on and then immediately turn off. I doubt its the ground wire because that had a good clean connection. A few things - the gauge of the power wire is very thin, and when I wired it to the battery the contact was not perfect to the terminal, But i would assume the amp would still turn on.. I feel like I've tried everything and nothings worked - Also I drive a 2008 honda fit. Any ideas? Thanks again!

 
Well how thin is thin ?and is ur ground same size as ur power ? Check ground make sure it’s grounded at a good spot and scrape paint away to make sure it’s making good connection. Also if u have a dmm check to make sure ur getting voltage at amp Could be lots of dif things how is sub wired maybe giving amp ohm load it doesn’t like

 
Probably like the thinnest it can possibly be. The spot were its grounded is completely clean and its making good contact with the metal so it can't be that. The amplifier still will not turn on even with the speaker not plugged in so I don't think it's that either.

 
agreed with others. Using a Dmm (digital multimeter), check the volts at the amp.

Checking if the amp is receiving power is where you want to start. Then people can suggest which direction to look next.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Those subs are 400w RMS each, and that dual enclosure is 800w RMS with a 2ohm load. That's a 4ch amp that does 55w x 4 @ 4ohm, & 75w x 4 @ 2ohm...
2
807
Many moons ago I was heavy into Car Audio Systems(Iasca stuff) but a ton of things have me removed and knowledge forgotten so I need a refresh. I...
0
802
What is your budget? With being exposed to Rain.. I would recommend looking at a marine grade SAS Bazooka for the sub stage
3
283
Don't forget Hoffman's Iron Law. You can have 2 of the 3: low end, efficiency/sensitivity or small enclosure size...
4
363
I have a Y as well, so many options you can go with. I'm running 500 watts to a JL 10W6v2 and its more than enough output for me (1.25 @ 32hz)...
12
536

About this thread

maxlaitinen93

Junior Member
Thread starter
maxlaitinen93
Joined
Location
Boston
Start date
Participants
Who Replied
Replies
4
Views
616
Last reply date
Last reply from
West1
IMG_3567.jpg

RedRyder18

    May 11, 2024
  • 0
  • 0
IMG_3568.jpg

RedRyder18

    May 11, 2024
  • 0
  • 0

New threads

Top