OP
AlmightyStryker
Junior Member
- Thread Starter
- #16
Ya 5 1/2 is just barely to deep. I figured 3 10s at 300rms each 900 total sealed would out perform 1 10 ported at 600rms.
Ya 5 1/2 is just barely to deep. I figured 3 10s at 300rms each 900 total sealed would out perform 1 10 ported at 600rms.
Why 4 6 1/2s over 3 10s sealed. Wouldnt the 10s go a lot further?It's actually 5-7/16", but I understand. I just dropped four 8's behind the seat of my Dodge standard cab. Your best bet is 4-6-½'s if you are on a budget or two JL 13tw5's sealed if you aren't on a budget. Just being honest.
Why 4 6 1/2s over 3 10s sealed. Wouldnt the 10s go a lot further?
I think there just above 5in. Box calls for no more then 5.25 mounting depth based on a 6in diameter magnet. 1.5 cbftWhat is the mounting depth of the 10's and air space available?
A nice back in the day setup ....You should put a blowthrough behind your seat.
A nice back in the day setup ....