Sub RMS Question
- Thread starter ballinizme
- Start date
- Replies 2
- Views 324
-
2Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
I ran 1200 watts through 12 gauge. Didn't notice any melting on the wire's insulation.
- Started by Aryan
- Wiring, Electrical & Installation
DJ subs are designed for efficiency, car audio subs are designed for low end in a small space. So above ~50hz the DJ sub will kill a car audio...
- Started by ianik777
- General Car Audio
Thank you guys!
I will lower the gains with the multimeter as I have watched the youtube.
- Started by Johnnie
- Subwoofers
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
About this thread
New threads
-
-
Has anyone used DataSat Amplifiers?I have a DataSat home theater system in my media room and I...- Started by Steve IZZI
- Replies: 2
-
I need Help picking the right amplifierAny recommendations for a 5 channel amp that has a 4 ohm f/r...- Started by Zach H
- Replies: 12
-
Advice: will I have enough high frequency quality / volume?I am planning out a system for my ‘04 Ram 1500 with the...- Started by Adam LaFountain
- Replies: 8
-
RCA output questionMy son is wanting to add a 4-channel amp to power his door...
- Started by RGKeller
- Replies: 8