Stinky after recone?

[bunkerking09 10+ year member]

i see the coil...already starting to darken...shit...

 

[bhsdriller 10+ year member]

I was just looking at a picture of one. Right above the top of the motor and in between the basket there's a gap...you can see the coil through there

Editops too late

 

[Cravingbass123]

ur an idiot lmao

u see ur pillars that separate the motor from the basket, what do the windings that you see look like???

 

[bunkerking09 10+ year member]

I was just looking at a picture of one. Right above the top of the motor and in between the basket there's a gap...you can see the coil through there

refer to above post lol

 

[bunkerking09 10+ year member]

ur an idiot
u see ur pillars that separate the motor from the basket, what do the windings that you see look like???

ur way behind man.

 

[bunkerking09 10+ year member]

why the hell would it do this if they are being GREATLY underpowered?

 

[Brian Owens 10+ year member]

Clipping can cause the effective RMS power to theoretically be as much as the peak power, although it would sound like a$$ and more than likely kill the amp.

If the coils are getting dark, too much thermal power for them. . .

Were they reconed with the correct coils?

 

[Cravingbass123]

ur way behind man.

no i wasnt i posted that the same minute u posted that.

i would expect someone with a pair of dp's and close to 4k posts on a car audio forum to know where to look for the vc lmao

 

[bunkerking09 10+ year member]

Clipping can cause the effective RMS power to theoretically be as much as the peak power, although it would sound like a$$ and more than likely kill the amp.
If the coils are getting dark, too much thermal power for them. . .

Were they reconed with the correct coils?

yes both D2

 

[slam 5,000+ posts]

thickness of the coils matter too

 

[Brian Owens 10+ year member]

you are either clipping the heck out of the amp, or something is wrong with that recone job. . .

 

[jonesy 10+ year member]

Fail

 

[bhsdriller 10+ year member]

Fail

x2

 

[bhsdriller 10+ year member]

no i wasnt i posted that the same minute u posted that.
i would expect someone with a pair of dp's and close to 4k posts on a car audio forum to know where to look for the vc lmao

lol

 

[bunkerking09 10+ year member]

ok, so sub wiring > me.

I made a stupid mistake.

So i take it around the block to see how it sounds without annoying my next door neighbor, turn it up to my "listening level" and the subs start to go bonkers. I unplug my ipod, but they don't stop. I flip my killswitch to the 4000D to turn it off. Flip it back on with the volume down, its in protect, off again, flip it on again, sounds fine, then i turn it up and it does the same thing.

Now its doing that pattern...suggestions?

EDIT: and it wasn't doing this when the subs were out of phase