staticy channel at low volumes

  • 3
    Participant count
  • Participant list

ragefan2k

Junior Member
2
0
ct
I have a 240 watt sherwood amp for my high's the prolem is , is one of the channels is staticy and liek doesnt work at all when the volume is low , but on high volume it sounds fine .... any suggestions on what it could be .... loose solder joint or is it something more serious

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
104
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
351
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
732
Slapz are sfb clones from my understanding. What I was pointing out is how much info slapz gives about their amps 😂
35
2K
Thanks for that. Good point about the chimes, I 'll have to check. My thoughts were that a true center channel could serve to raise the sound...
3
432

About this thread

ragefan2k

Junior Member
Thread starter
ragefan2k
Joined
Location
ct
Start date
Participants
Who Replied
Replies
2
Views
376
Last reply date
Last reply from
MikeofTulsa
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0

New threads

Top