I have a 240 watt sherwood amp for my high's the prolem is , is one of the channels is staticy and liek doesnt work at all when the volume is low , but on high volume it sounds fine .... any suggestions on what it could be .... loose solder joint or is it something more serious
-
3Participant count
-
Participant list
Trixter 10+ year member
Keepin it Simple
You could try checking the RCA connections. They will cause static and when you turn it up you simply don't hear it.
MikeofTulsa Moderator
The one and Only!
make sure you have a good ground for the amp
Activity
No one is currently typing a reply...
Similar threads
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
- Started by RyanJ0022
- General Car Audio
Pretty much. It's just a nice kit.
A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
- Started by JoeMama541
- Amplifiers
Slapz are sfb clones from my understanding.
What I was pointing out is how much info slapz gives about their amps 😂
- Started by Doxquzme
- General Car Audio 2 3
Thanks for that. Good point about the chimes, I 'll have to check. My thoughts were that a true center channel could serve to raise the sound...
- Started by maylar
- General Car Audio
It is Opel (Vauxhall) Astra J 2011 model, I change the HU to Kirinavi 10 inch screen. The factory speakers are Infinity and would have come with a...
- Started by David Simm
- Amplifiers
About this thread
New threads
-
-
-
-
Head unit 1 output rcas, to 5 channel amp, LOC or 1 set off HU
- Started by RyanJ0022
- Replies: 6
-