SAZ 1500 1 ohm wiring question.

[maritoze 10+ year member]

I'm a bit puzzled on how Sundown shows it's diagram. When I wire two DVC 4ohm subs parallel it should end up at 1ohm correct? Which terminals do I use on the amp? Why is there two positives hooked in the diagram? Where the hell is that negative going to also? Can anyone clarify how I should wire them?

Click to read more...

 

[Side Show 10+ year member]

hehehe

 

[maritoze 10+ year member]

hehehe

I suppose you know the answer and are amused with my conundrum.

 

[BloodyGuts335i 10+ year member]

you wire all the positives on both subs and going to the amp there should be 1 positive wire.. then you wire all the negatives of each sub . there should only be 1 negative wire going to the sub..

then you put the + wire to a + spot on the amp and a - on a - spot on the amp..

 

[inkfx 10+ year member]

bang bang pow pow!!

 

[fasfocus00 5,000+ posts]

try reading the owners manual, you'll be amazed a what the fuk reading can do for you.

 

[Wingsfreak9 10+ year member]

bang bang pow pow!!

ha bang bang pow pow is right

 

[maritoze 10+ year member]

try reading the owners manual, you'll be amazed a what the fuk reading can do for you.

I did read the owners manual you ***. That image is from the owners manual.

 

[roarzorz 10+ year member]

+ to +

- to -

Wires all coils parallel. The amp is a monoblock so both it's + output terminals are connected parallel internally. Same for the - output terminals.