Sa-8 ported enclosure ?

Florida_BOY
10+ year member

Member
THIS IS MY CALCULATIONS....

1.5cu.ft Tuned to 35Hz

Subs will most likely be powered by a POWERBASS SA1000.1D

Subs are DVC 4ohm wired to 1 ohm

This will be in a daily driver, but would like them to get low as they can while still sounding good with Rock as well

 
.6 @ 35 hz is the recommended enclosure. you're over double that... 1.5 might be ok for 2 SA8s. But Sundown suggests no larger than .6 for any amount of power.
Yeah, he's going with 2 8's. That 1.5 will work, but careful on the amount of power you put to them.

 
Yeah, he's going with 2 8's. That 1.5 will work, but careful on the amount of power you put to them.
I got that after rereading the original post...but its still on the large side. Possible get away with it on RMS power. But it has been said many times by the owner no larger than .6 is recommended.

 
Yes, the question is...

Is this enclosure too big/small for (2) SA-8 subs with 1000 watts powering them.

Would anyone recommend a higher/lower tuned enclosure?

 
I got that after rereading the original post...but its still on the large side. Possible get away with it on RMS power. But it has been said many times by the owner no larger than .6 is recommended.
Perhaps you should go to the Sundown site and read...Jacob recommends 0.6 to 1.1 ported per driver.

With that said, 1.5 should be perfect for a pair of them.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Florida_BOY

10+ year member
Member
Thread starter
Florida_BOY
Joined
Location
Florida
Start date
Participants
Who Replied
Replies
42
Views
4,665
Last reply date
Last reply from
Florida_BOY
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top