Running 0 gauge

[uGotF-ckedUp 10+ year member]

anyone have any pics of where and how they ran there 0 gauge wire?

do most of you run it in the car or under?

Click to read more...

 

[kyleorsini 10+ year member]

run it under the carpet by the door sills

 

[bhsdriller 10+ year member]

I ran it under my truck, than came up in a factory grommet

 

[skmfkr 5,000+ posts]

I ran it under my truck, than came up in a factory grommet

same here. ih my fit i had to drill the firewall hole bigger and i ran it under the carpet

 

[plugitin 5,000+ posts]

mine will be inside...ran down the side covered by the door trim

 

[Pioneer~Saturn 5,000+ posts]

mine will be inside...ran down the side covered by the door trim

x2 if you can fit it under everything and have it go back together well

 

[MmatsDude 10+ year member]

on top through the roof

 

[Lambo911 10+ year member]

Inside the car, under door trim.

 

[csu87 10+ year member]

i ran it right down the middle of my car under the carpet. it was a pain to get everything out but you cant see the big bulge from the 2 runs of 1/0 wire

 

[DonH 5,000+ posts]

never knew 0 guage could run let alone walk! in for vids!

 

[jshak07 10+ year member]

Pull the seats, pull the carpet and run it where you can put everythting back in without the wire being in the way.

 

[z0n3d0u7 10+ year member]

Pull the seats, pull the carpet and run it where you can put everythting back in without the wire being in the way.

x2. May not even have to pull the carpet completly, I just folded mine. However one day i will be pulling the carpet to do some work to the floor boards, Dynamat, And a carpet kit, So it'll probably get "re-done" then.

 

[ultimate157 5,000+ posts]

Pull the seats, pull the carpet and run it where you can put everythting back in without the wire being in the way.

I ran mine this way in the grand cherokee. Was doing other work at the same time, so I stripped the whole interior to install new leather/power seats + wiring. Ran it underneath the carpet, under the passenger front seat, then towards the door sills to under the rear seats.

All other installs have been in through the passenger footwell, down the door sills under the molding.

 

[th3disturbed1 10+ year member]

All my bolts were so rusted I couldn't pull the seats out so I had to make do with running the wire under the carpet about 6 inches in. I pulled up the carpet as far as possible and ran it under just past the seat belt bolt in my cavi. It doesnt bulge though which is nice

 

[quins90lac 10+ year member]

on top through the roof

do you have pics of this