Hey all, new guy here with his first post. Need some help with wiring a remote turn on wire for a Rockford Fosgate p300-10 powered sub.
Little back story to let you know what I’m doing. 1984 foxbody mustang gt. Didn’t want to destroy the factory original dash so decided to install a Kenwood KAC m5024BT amp to run 4 speakers and then added a p300-10 for some extra bass.
Ran the remote wire for the amp to a factory amp pull switch that was in the car stock.
I need to run a remote wire for the sub and am wondering if I can tie into the wire I ran for the BT amp and connect to the same 12v switched source? So basically they both turn on when the switch is pulled.
Thanks
Little back story to let you know what I’m doing. 1984 foxbody mustang gt. Didn’t want to destroy the factory original dash so decided to install a Kenwood KAC m5024BT amp to run 4 speakers and then added a p300-10 for some extra bass.
Ran the remote wire for the amp to a factory amp pull switch that was in the car stock.
I need to run a remote wire for the sub and am wondering if I can tie into the wire I ran for the BT amp and connect to the same 12v switched source? So basically they both turn on when the switch is pulled.
Thanks
Last edited:
