remote turn on issue with LOC....solutions???

jjoseph8907
10+ year member

Junior Member
Alright so I am using a LOC to run the signal to my amp as I opted to continue to use my factory deck, only one problem - how do I connect the remote turn on to my amp?? I cannot do this through the LOC as far as i know, and I would more than willingly run the line to my OEM deck, but it doesnt support me connecting a remote turn on line to it as far as I know. I read that I could connect the wire to any device which turns on when i turn my key to the ACC position, but I cannot think of any of these that would be easily accessible and that I would be able to connect to. Any solutions to this problem? Is there any way I could splice and connect the wire to the speaker wire which i have spliced and connected with the LOC and seal it with electrical tape? would this work? It doesnt seem like a major problem but i cant figure out a fix....

Thanks in advance for the help

 
You can get a cheap Haynes or Chilton manual for your vehicle and it contains electrical schematics as well as mechanical step by step repair. Get yourself a test light and find a source of power only when the key is turned on, but ideally you want remote off of the factory deck.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

jjoseph8907

10+ year member
Junior Member
Thread starter
jjoseph8907
Joined
Location
St. Petersburg, FL
Start date
Participants
Who Replied
Replies
4
Views
720
Last reply date
Last reply from
jjoseph8907
1778763859842.png

Doxquzme

    May 14, 2026
  • 0
  • 0
IMG_20260513_214311575.jpg

ThxOne

    May 13, 2026
  • 0
  • 0

New threads

Top