I would like to get Polk MM651 speakers to connect to my R/F PBR300X4 amp but it's rated for 4 ohms only. Will I have a problem if I run the Polk MM651 which are 2.7 ohms? I like that speaker because it sounds pretty good and they are marine grade and these are going on a motorcycle.
-
2Participant count
-
Participant list
winkychevelle
10+ year member
CarAudio.com Veteran
it will more than likely send the amp into protect, even if it doesnt that amp is going to get hot at hell any prolly turn into a paper weight
Activity
No one is currently typing a reply...
Similar threads
It also lowers the amps efficiency and raises the current draw.
- Started by Paul Curtis
- General Car Audio
What is the impedance of each set of terminals,assuming they represent each of the two dual voice coil subs (4 coils total)?
How many sets of +/-...
- Started by tbcopeland1
- Wiring, Electrical & Installation
Not all chargers are the same and charge and different rates. Any battery will deplete in that type of weather if you do not crank the vehicle for...
- Started by Bluecarz77
- Amplifiers
FOR SALE
Taramps md3000.1 1 ohm new
Brand new
210 shipped
TECHNICAL INFORMATION
OPERATION CLASSClass D
NUMBER OF CHANNELS01
MAXIMUM POWER@ 12.6 VDC - 1 OHM: 3000W RMS
@ 12.6 VDC -...
- Started by mclerico1983
- Car Audio Classifieds
This is what I usually do before I put my main gear in. For my temp setups, Ill thrown in what I have close by out of my stash.
- Started by jeff47424
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 1
- Views
- 1,829
- Last reply date
- Last reply from
- winkychevelle
New threads
-
Pionner AVH-P3350BT, remote does not work (blue-white)Tengo una radio pioneer AVH-P3350BT, pero el control remoto...- Started by pedro carbet
- Replies: 1
-
AI Subwoofer enclosure designerHi everyone, I made a custom GPT on OpenAI, just search for...
- Started by BoomBoomBoxBuilder
- Replies: 1
-
Whining noise in SpeakersI have a 1997 Chevy C1500 OBS. Currently running Alpine...
- Started by 97obs
- Replies: 3
-
Vintage Lanzar 12 inchHi Has anyone got the data sheet for an old Lanzar sub? I...
- Started by Mmatt
- Replies: 0
-
