port for a 4th order bandpass box

waterstone
10+ year member

Junior Member
Hi I just planned a 4th order bandpass box for this sub:

WoofersEtc.com - REF-TM12.2 - 12" Tidal Audio Subwoofer Dual 2 Ohm OEM by Image Dynamics

Nominal Impedance (IMP) 1/4 ohms

DC Resistance (Re) .98 / 3.8 ohms

Resonant Frequency (Fs) 20.7 Hz

Electrical "Q" (Qes) .412

Mechanical "Q" (Qms) 3.80

Total "Q" (Qts) .372

Equivalent Volume (Vas) 5.71 cu. ft.

One Way Linear (Xmax) 17.0 mm

Cone Area (Sd) 545 cm2

Sensitivity (Spl) 88.6db

RMS Power Handling (Pwr) 50 to 400W RMS

Speaker Displacement .07 cu. ft.

Mounting Depth: 6"

Mounting Diameter: 11"

I was wandering if a 39 square inch port area would be big enough. Its a 13 per 3 inch port slot.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

waterstone

10+ year member
Junior Member
Thread starter
waterstone
Joined
Location
los angeles, CA
Start date
Participants
Who Replied
Replies
0
Views
975
Last reply date
Last reply from
waterstone
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top