Orion 8002 to 2 SE 12's

[BlastingBeats]

2 12 inch subs are d4's

8002 specs

how much power can i get for this amp to each sub.

how do i wire it ( i checked the diagrams n could nt find)

thanks

Click to read more...

 

[BlastingBeats]

specs on amp

Number of Channels: 2

RMS Power (4 ohms): 200 watts x 2 chan,

RMS Power (2 ohms): 400 watts x 2 chan.

RMS Power (1 ohm): Not Stable

Bridged RMS Power: 800 watts x 1 chan.

Peak Power Output: 1600 watts approx.

Min. Impedance Unbridged: 2 ohms

Min. Impedance Bridged: 4 ohms

 

[80INCHES 5,000+ posts]

I WOULDNT DO IT....i would get the orion 1200d..its a perfect combo

80

 

[BlastingBeats]

I WOULDNT DO IT....i would get the orion 1200d..its a perfect combo
80

yea, the 8002 is only temp.

how would i wire it?

the way i see its.

it would be wired into a 2 ohm load to each channel. D4= 2 ohm load to each channel

2 channel on that amp so i would be getting 400 a peice

 

[Hydrastas 10+ year member]

If it's just 'temp' then i'd bridge it to a 2 ohm load... lol

 

[Hydrastas 10+ year member]

I mean i'd bridge both speakers to a 2 ohm load

 

[Hydrastas 10+ year member]

nvm it's probably got some protector shit that'll stop that from happening, thats why i like the older amps

 

[BlastingBeats]

ok, then how do i wire the se's

 

[helotaxi 5,000+ posts]

Hydra-you are the absolutely worst person to give any advise on this topic, shut up.

Blasting-Wire each sub's coils in series. Connect the neg of one coil to the pos of the other. Then wire the subs in parallel. The open pos of each sub to the pos of the amp and the same with the neg. Use the terminals indicated on the amp for bridged operation for the pos and neg. That will give you the max power from the amp (800W @ 4 ohms bridged) and will feed a mono signal to the subs minimizing cancellation.

 

[Hydrastas 10+ year member]

lol, i've had lots of experience on this subject actually, but i would still go with bridging both subs to the amp at a 2 ohm load, get the most power, but the amp will fry, but who cares it's just 'temp'.

 

[helotaxi 5,000+ posts]

You can't bridge the amp to 2 ohms with those subs, you complete idiot. You proove every time that you post that you are a complete idiot when it comes to car stereos. I would actually feel sorry for someone naive enough to listen to any of the retarded advice that you keep spouting. You have NO, ZERO, ZIP, ZILCH useful experience on any matter regarding car stereos except how to ruin equipment through stupidity. GO AWAY or learn something. Either way, STFU!