I have a pair of diamond audio hex 6.5's (150 rms svc 4ohm) and an 05 Re xxx 12. (Splaudio is going to be reconing the sub to fully wang at 1k rms) I need an amp for the speakers and an amp for the sub ( i only mention the sub becuz of the s4a listed below). I am more worried about my front stage at this time.
DD S4A - s4b is the current one specs r close... 100x2 front channels 200x2 rear channels 4 ohms stereo
600x1 bridged on rear channels @ 4ohm ( will go down to 2 ohms but no power ratings were put out)
^Would run both speakers and subs with this ^
I am also looking at a
Tru Technology S45
4 STEREO RMS
90W x 4
2 STEREO RMS
125W x 4
4 STEREO + MONO RMS (3CH)
90W x 2 + 250W x 1
4 MONO RMS (DUAL-MONO)
250W x 2
And Last but not least
a
DD C3B
Cont Power at 4 ohm 200W x 2ch
Cont Power at 2 ohm 300W x 2ch
Bridged 600W x 1ch
might be open to other opinions... this is what i have found so far
