Ohm rating of a JBL 6x9??

  • 1
    Participant count
  • Participant list

PWNED
10+ year member

Senior VIP Member
Just picked up a 99 Regal with the monsoon system. The rear 6x9's are 2 ohms and the 4 inch mid is 4 ohms. Because the sytem has a factory amp. Now the dilemma is if I just put an aftermarket 4ohm 6x9 in its place all i will have is tweeter and no bass. I found a set of used JBL GTO Series 6x9 speakers model # GT0925 for dirt cheep. Wondering if any one knows what the ohm rating is on these. I see alot of the newer JBL's are 2 ohms.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It also lowers the amps efficiency and raises the current draw.
5
619
What is the impedance of each set of terminals,assuming they represent each of the two dual voice coil subs (4 coils total)? How many sets of +/-...
2
422
Not all chargers are the same and charge and different rates. Any battery will deplete in that type of weather if you do not crank the vehicle for...
10
1K
Brand new 210 shipped TECHNICAL INFORMATION OPERATION CLASSClass D NUMBER OF CHANNELS01 MAXIMUM POWER@ 12.6 VDC - 1 OHM: 3000W RMS @ 12.6 VDC -...
0
738
This is what I usually do before I put my main gear in. For my temp setups, Ill thrown in what I have close by out of my stash.
10
1K

About this thread

PWNED

10+ year member
Senior VIP Member
Thread starter
PWNED
Joined
Location
Hooksett,NH
Start date
Participants
Who Replied
Replies
0
Views
721
Last reply date
Last reply from
PWNED
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0

New threads

Top