Posted this in the wiring section, but it doesn't get much traffic and I think more people know me in here..Does anyone know approximately how many feet I will need? I have a 2000 Mustang. I want to do the Big 3 with 1/0, then do a run of 1 or 2 gauge back to my AX 5600. It accepts 1 gauge, so should I just do 1 gauge from the battery back? Please break down a list of everything I will need to do this. Fuse holders, battery terminals, connectors, etc. I want to order everything from Knu Koncetpz, but their site is down, so I was just going to get it all off their
ebay store. I want to get new speaker wire too. How much will I need for my comps? I am going active so I will need enough for the two tweets and two mids. Can I use the same gauge for both? Also, for my 10" ME sub that I am about to get, should I get some 8 gauge for that? So please tell me all that I need from here:
http://stores.ebay.com/KnuKonceptz-com_W0QQcolZ2QQdirZQ2d1QQfsubZ0QQftidZ2QQtZkm
Thanks in advanced. If you know anyone selling anything used, I wouldn't mind. I want the red 1/0 power wire and black 1/0 ground. I'd also like the twisted speaker wire...
Btw, my new ES-6 mids are in and my AX 5600 arrived today (possibly going to pick up a used 10" ME from someone on here...waiting for more pics from him), but I didn't take any pics yet because I still can't find my camera battery charger and I just went in to Wolf to try and find one, but found out that Minolta sold out to Sony, so there is no backwards support. I may have to buy a new fricken camera. Also, I since I plan on running the comps active, I figure I wouldn't take any pics until I get everything wired up (and some modeling clay on the doors). Got 1 layer of Dynamat on the doors, but they are far from sealed. Haven't done the trunk yet, but I didn't really have any big vibration problems with my 2 10" Type-Rs, so I should be okay for now. Then I plan on Second Skinning the whole car over summer. Also going to be repainted some interior panels black that are fading...
