- Thread Starter
- #16
and I believe my setup is like this even in my HU I set my Networks with these settings
"going active" sounds more complicated than it is. With your equipment, I agree it is the right approach and it saves you from having to install a 2.2uF cap on the tweeters.
Simply wire from each speaker (tweeter or woofer) to the amp. Example:
Left tweeter in amp channel 1
Right tweeter on amp channel 2
Left woofer on amp channel 3
Right woofer on amp channel 4
From the HU, run a RCA pair from front/high out to channels 1&2 input. And run a RCA pair from rear/mid out to channels 3&4 input.
The front/high out will be setup in network mode for high pass crossover at 5kHz 18 dB/oct
The rear/mid out will be setup in network mode for band pass crossover at 80Hz 24dB/oct and 5kHz 18dB/oct
Running them in coaxial mode is a waste of equipment.
If you can't grasp these concepts, just ask for help from someone who does.