Need 10" for these box specs

[tmcilroy 10+ year member]

I'd like to add a sub with a clean install being one of the more important parts of it. There is a prefab ported box with the following dimensions and I was wondering if somebody could recommend me something based on them.

Vent width: 2.5"

Vent height: 2.5"

Vent depth: 2.5"

Mounting depth: 6"

Net cubic feet: 1.00

HZ: 39

I have a 600W RMS amp that will be used on this single sub. But may eventually lower it to a 400W if I decide to upgrade my factory speakers.

Thanks

Click to read more...

 

[Husker 10+ year member]

I had good luck with an American Bass TNT 10 in smaller sealed enclosures

 

[tmcilroy 10+ year member]

Thanks I'll look into that American Bass sub but I was hoping to take advantage of this ported box I already have that is custom built for under the back seat of my truck.

 

[mylows10 5,000+ posts]

Thanks I'll look into that American Bass sub but I was hoping to take advantage of this ported box I already have that is custom built for under the back seat of my truck.

thats a small ported box and most likely the tuning is higher than 39 hertz as is most prefab boxes .what amp are you running for the sub and what coil configuration do you need ?

 

[tmcilroy 10+ year member]

I have a Kicker KX600.1 which I think is rated around 650W at 2ohms. So either a 4ohm DVC or 2ohm single. I'll be using just 1 sub.