mounting depth

EarDrummin.
10+ year member

Is this my Brahma?
3,542
0
Wanaque, NJ
I think 2 inches from the back was the magic number. Need to let the air in your pole vent. By the way, you'd need to mount that pretty well, or it would tip over rather easily.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Holefully he doesn’t hook batteries in series thinking it halves the voltage…..
29
1K
It is a wives tale if the only evidence could be coincidental. I agree that vibration is bad for everything except women, but that doesn't mean you should factor it into amp location. Two...
32
5K
I would put two Eyelets on front and back close to the bottom of the enclosure with Toggles, rubber washers, and metal washer to seal the penetration to have a rigid hold down. Then run a ratchet...
3
943
just use riv-nuts or clip-nuts, made for blind fastening. some window weld should hold the ring on there pretty good..... being 4x6, you could even do a steel or aluminum adapter plate, just...
4
1K

About this thread

jeffd398

10+ year member
Junior Member
Thread starter
jeffd398
Joined
Location
West Palm Beach, FL
Start date
Participants
Who Replied
Replies
1
Views
399
Last reply date
Last reply from
EarDrummin.
IMG_5559.jpeg

Buck

    Feb 22, 2024
  • 0
  • 0
IMG_5558.jpeg

Buck

    Feb 22, 2024
  • 0
  • 0

Latest topics

Top