massive audio p3000 is confusing the hell outta me.

[tank65 10+ year member]

well heres the deal.

i want to wire it to 4ohms 1800x1 so would i wire both subs at 2 ohms and then wire all positives to the 2ohm positive on the amp and all negs to the 2ohm neg?

im tryin to pull as much power as possible with dvc4 kicker l7's. and 4ohms at 1800w x 1 is the best i can seem to do according to the manual

Click to read more...

 

[tank65 10+ year member]

im scared to run both channels together and wire the subs into 1 ohm.. since it doesnt say it will run 1ohm x1 stable

 

[squeak12 10+ year member]

Wire each sub parallel (connect the positives and negatives)

If you have DVC4 that will make each sub a 2 ohm load.

Wire each sub to one channel. This should provide you with 950 watts to each sub.

OR

Wire each sub series (Connect VC1 positive to VC2 negative)

This will give you two 8 ohm subs assuming DVC4

Then wire each subs positive together and each subs negative together and use the outside posts on the amp.

That will do 1800 watts total (900 per speaker)

 

[tank65 10+ year member]

k so wire each sub like this..

and each sub to its own set of terminals to hit 950rms per sub? if thats how that will work out fine for me.