looking to upgrade

[demon817]

Ok n what's the diff. When I put your subwoofer backwards in the box

 

[demon817]

Yeah I told him knukonceptz works great at a great price

Is that amp kit long enough for my suburban cuz most of them ain't long enough

 

[Nutdawg651]

Is that amp kit long enough for my suburban cuz most of them ain't long enough

Not sure but they should have some 17 ft kits if not just call them and order the kit and tell them you need 17 ft power and 3-4ft ground and theyll just charge you for the extra length

 

[Nutdawg651]

Ok n what's the diff. When I put your subwoofer backwards in the box

Gives the box a little more volume on the inside , looks good , and not sure how much better it is on cooling the woofer but I would think so just because itll get more air,

 

[demon817]

Ok I always wonder about that

 

[demon817]

Well I was outside Messina with my system so I went ahead and bridge it hits twice as hard but it's blow my power wire fuse should I put a bigger fuse

 

[Nutdawg651]

No unbridge it your running at 1 ohm thats a 4 ohm stable while bridged remember that story I told you youll fry your amp and start a fire I bet it was hot as fukk and got smelly , the one way you can run your amp bridged is at 4 ohms is your subs dual voice coils? And if so are they 4 or 2 ohms

 

[demon817]

No unbridge it your running at 1 ohm thats a 4 ohm stable while bridged remember that story I told you youll fry your amp and start a fire I bet it was hot as fukk and got smelly , the one way you can run your amp bridged is at 4 ohms is your subs dual voice coils? And if so are they 4 or 2 ohms

Idk if it's dual vocie cool but they are 4 ohms subs

 

[demon817]

They are single vocie coil 4 ohms

 

[Nutdawg651]

Ok so with single vc you were running a 2 ohm load , you only want to bridge a 4 ohm load on that amp

 

[Nutdawg651]

You should find a mono amp that is 2ohm stable build a new box and put 600 watts to both paired and add polyfill in your box theyll come alive

 

[demon817]

Ok is that why the fuse blown

 

[Nutdawg651]

Yes when you lower the impedance your telling the amp to draw more current in your case when it pops fuses it drew too much

 

[demon817]

Yes when you lower the impedance your telling the amp to draw more current in your case when it pops fuses it drew too much

Ok thanks man I didn't know that

 

[Nutdawg651]

Ok thanks man I didn't know that

Always here to help