JVC KD-X220 Display setup

  • 2
    Participant count
  • Participant list

DonB

Junior Member
I have a new JVC KD-X220 and am quite happy with the unit except for the display. No matter what setting I've tried, it reverts to a constant scrolling and updating after a few seconds. Is there any way to get it to just display what I select without the constant updating?

Cheers,

Don

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Google do it translate what ever i do
4
364
Hi, if no one here is able to help you figure it out, try over at diyaudio in the car audio section, it is a more technical forum. This is one of...
1
651
Usually when you shop for a replacement harness for your model, you will find the pictures may show you in what pins your wires go to.
1
671
Yes, the power wires' colors don't match from the dash to the new harness. However, I tested them and the wire I'm treating as the constant 12v is...
9
1K

About this thread

DonB

Junior Member
Thread starter
DonB
Joined
Location
Australia
Start date
Participants
Who Replied
Replies
1
Views
609
Last reply date
Last reply from
big scott
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top