BOON250
Junior Member
Hi
I have installed a JBL GTR-104 bluetooth amp. I am using JVC 60 W RMS 6.5 front components and JVC 70w RMS 6x9s in the rear and have a few questions
I am using the bluetooth input only as its in a classic car. I'm running the music off a 6s IPhone. I can hit half on the volume scale with no distortion and its pretty loud at that point.
It sounds pretty punchy and loud but I feel the front speakers are a bit tinny and the 6x9s are only a little bit bassy. So I have some questions....
1) The gain control appears to do nothing, I guess because its on bluetooth input- is this a problem?
2) Should I HPF the front components or run them full pass?
3) What filter should the 6x9s be on? High low or full?
4) should I move the tweeters closer to the woofers? They are sitting up on the top of the dash at present.
The soundstage sounds "full" inside the car and distortion isn't a problem, just a little lacking on bass I feel.
Any suggestions appreciated!
I have installed a JBL GTR-104 bluetooth amp. I am using JVC 60 W RMS 6.5 front components and JVC 70w RMS 6x9s in the rear and have a few questions
I am using the bluetooth input only as its in a classic car. I'm running the music off a 6s IPhone. I can hit half on the volume scale with no distortion and its pretty loud at that point.
It sounds pretty punchy and loud but I feel the front speakers are a bit tinny and the 6x9s are only a little bit bassy. So I have some questions....
1) The gain control appears to do nothing, I guess because its on bluetooth input- is this a problem?
2) Should I HPF the front components or run them full pass?
3) What filter should the 6x9s be on? High low or full?
4) should I move the tweeters closer to the woofers? They are sitting up on the top of the dash at present.
The soundstage sounds "full" inside the car and distortion isn't a problem, just a little lacking on bass I feel.
Any suggestions appreciated!