REF350.2
Two Channel
Amplifiers
Stereo, 4 ohms: 2x100 Watts
Stereo, 2 ohms: 2x175 Watts
Bridged, 4 ohms: 1x350 Watts
T.H.D. + Noise:
S/N Ratio: >95dB
Slew Rate: >29V/uS
Damping Factor: >200@4 ohms
Dimensions: 15"L x 7.5"W x 2"H
-SymbiLinkル Balanced Inputs
-RCA Unbalanced Inputs
-2 ohm stereo stable
-18 dB variable bass boost
-Built in variable electronic crossover
-Bridgeable
-Three channel capable
-High Current Bi-Polar output devices
-Optically isolated MOSFET power supply
-Switch for use as stereo, single L ch. or R ch. bridge
-L+R Sum Mono switch for use as bass amp
-Surface mount technology w/1% resistors,
precision caps, and massive ground planes
JBL 600.2 (birth sheet shows 655 wrms bridged)
Amplifier Type: 2-channel
RMS Power @ 4 Ohms: 180W x 2 @ 14.4V
THD at 4-Ohm RMS Power:0.04 %
Bridged RMS Power @ 4 Ohms:580W x 1 @ 14.4V
Speaker Level Inputs:No
Preamp Outputs: Yes
Built-In Crossovers: HP/LP
Bass Boost: None
Frequency Response: 10-97,000 Hz
Signal to Noise Ratio:79.5 dB
Fuse Rating:n /a
Full MOSFET Power Supply
"Direct Connect" Terminal Block Allows for 4 or 8 Gauge Power Wire
Die-Cast Aluminum Chassis with Top Plexiglas Viewing Window
Variable High-Pass / Low-Pass Crossover (32-320 Hz)
Selectable Crossover Slope (12 / 24 dB)
Dynamic Bass Optimization (DBO) Subsonic Filter
Preamp Outputs
Fully CEA-2006 Compliant Power Ratings