I am having huge difficulty with op amp circuit

[Bryant11]

I am having huge difficulty with op amp circuit used in TA7642 radios, I cannot figure out how to attach the lm301 chip to have a gain of more than 200 (10 u cap between pin 1 and if I give it too much signal in 50 k ohm pot then the radio just makes a farting noise. My problem is that I need to figure out which lowpass or highpass filtrations between the speaker pin 5 and the 470 n capacitor and which resistors I need to reduce the hissing noises without any distortion or clipping when I try to make it louder.

Click to read more...

 

[hispls 5,000+ posts]

Pretty sure this is way beyond the scope of anything anybody here deals with. You may have some luck over at DIYaudio.com where there's some electronics guys who post.