antibiotic1
Junior Member
Hello, my setup is next:
Precision power ppi 640.5
JBL GT5-1204br subwoofer
4 JBL gt7-68 speakers
https://www.rockvilleaudio.com/rwk4cu/
I had installed the subwoofer.I am splitting one of the two channels to another 2 channels in order to have 3 rca inputs for my amp, 1 for the channel 1 and 2, one for the channel 3 and 4, and 1 for the sub.(the rca signal from the front speakers is splitted for the channel 1 and 2 , and for the sub ). Also i replaced the door speakers. The next step to do is to run wire's from the amp to the back of the radio , where i will connect this wires to the old wiring(i hope i am clear)
My question is can i bridge the 4 output channels from my amp into 2 channels(this cables will get to the radio with 4 wires) and then connect my 4 car speakers on this 2 channels?For example the 2 front speakers will be connected to the first pair of wires and the rear speakers to the secound pair of speakers . The amp rms for each channel is 60w rms and the door speakers are 60w rms each as well at 4 ohm.
My main plan is to get the output sound signal from my amp to the back of the radio(where i will connect this wires to the old speaker wires) but with using only 4 wires
Precision power ppi 640.5
JBL GT5-1204br subwoofer
4 JBL gt7-68 speakers
https://www.rockvilleaudio.com/rwk4cu/
I had installed the subwoofer.I am splitting one of the two channels to another 2 channels in order to have 3 rca inputs for my amp, 1 for the channel 1 and 2, one for the channel 3 and 4, and 1 for the sub.(the rca signal from the front speakers is splitted for the channel 1 and 2 , and for the sub ). Also i replaced the door speakers. The next step to do is to run wire's from the amp to the back of the radio , where i will connect this wires to the old wiring(i hope i am clear)
My question is can i bridge the 4 output channels from my amp into 2 channels(this cables will get to the radio with 4 wires) and then connect my 4 car speakers on this 2 channels?For example the 2 front speakers will be connected to the first pair of wires and the rear speakers to the secound pair of speakers . The amp rms for each channel is 60w rms and the door speakers are 60w rms each as well at 4 ohm.
My main plan is to get the output sound signal from my amp to the back of the radio(where i will connect this wires to the old speaker wires) but with using only 4 wires