How to properly install???

[sealw98 10+ year member]

I'm in need of the proper soultion to hooking up my 3 amps in the trunk. I have 2 mono amps that run at 1250watts each and are fused at 120amps each and then I have my 4channel that is 250.4 and it is fused at 60amps. I'm being told to run 0 guage from the battery to a dis. block where it will split into 4guages for each of the amps is this correct and is there anything else I should be aware of?

Click to read more...

 

[WantedIsHere]

there is no set proper way.... you could do many things including runs for each amp etc... all depends on how you want to do it...

 

[Skip01 5,000+ posts]

You can add a 2nd batt in the back and make it a lil easier...and you may need it with that amount of power

But you can do it with the distro block...go for it

 

[indosia 10+ year member]

I'm in need of the proper soultion to hooking up my 3 amps in the trunk. I have 2 mono amps that run at 1250watts each and are fused at 120amps each and then I have my 4channel that is 250.4 and it is fused at 60amps. I'm being told to run 0 guage from the battery to a dis. block where it will split into 4guages for each of the amps is this correct and is there anything else I should be aware of?

0 awg with a 300 amp fuse near batt. See if you can get a fused disribution block. Be aware that your vehicles charging system will need to be upgraded.