How to cut 45's with a circular saw?
- Thread starter trenthonda1
- Start date
- Replies 2
- Views 926
-
- Tags
- angled cuts
3" is typical... seen some 2" ones also
keep_hope_alive Premium Member
Acoustics Engineer
you making bracing? if you need thin strips that have 45's, work on the master piece, and make cuts with the blade on the angle to begin with. if you need to reverse the angle, flip the board.
Activity
No one is currently typing a reply...
Similar threads
If you buy a replacement OEM Radio Harness the colors will match up then you can use a wiring harness to connect to that. According to a few...
- Started by Mike Hunt
- Wiring, Electrical & Installation
Do you know what the box/port tuning is?
And what is the db/octave slop on the crossovers being used? Setting the amp crossovers as open as...
- Started by surreal89
- Subwoofers
If I was in your situation, I would experiment with the wring for a day or two. If that didn't work, I would purchase an external amplifier. Run...
- Started by Expertnewb
- Head Units
Yeah well im a maintenance technician working 12 hr days 6 days a wk ontop of school 3 times a wk which are 4 hrs long .so ya an hr drive is hard...
- Started by Bass so loud it HZ
- Enclosure Design & Construction
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 2
- Views
- 926
- Last reply date
- Last reply from
- keep_hope_alive
