how to add more speakers

[bradl79 10+ year member]

ok, so my HU only has 3 pre-outs, High, Mid, Sub. i have a set of components as u can see in my sig, but for some reason it sounds so crappy when i have the mids, tweets and imaging tweets on the crossover (CDT ex-540) (getting a crackle sound, i don't know how or why) so just kept the tweets on the xover and put the woofers as the mid pre-out and tweets on high pre-out, and sub on sub, but i want to keep those seperate but i want to add speakers to the rear, is there anyway to do that since i don't have any more pre-outs b/c i have the fronts active. thank you.

Click to read more...

 

[mylows10 5,000+ posts]

Splitter xnd add another amp. Or run the rears off deck power. Problem solved

 

[bradl79 10+ year member]

so if i get a RCA Splitter and run it off lets say the Mid RCA, then i can run my fronts active and run the rears also on just another amp, will that harm the HU at all.

can you point me in the direction for a good splitter i can use

 

[mylows10 5,000+ posts]

Won't hurt the amp or deck if one amp has a pass thru that would even be better. But some spotters from @Tenacious ; would be good

 

[bradl79 10+ year member]

mylows10, i have this on my amp, would this be the pass thru and would it work, or should i just go with splitters

 

[mylows10 5,000+ posts]

Use the out puts and a small 1-3' RCA

 

[bradl79 10+ year member]

it says its a mix of all 4 channels and connect it to a mono block, would it still be ok to still connect it to a 2ch amp?

 

[calebkhill 10+ year member]

Mono mix... Should take that into consideration.

There will be no stereo separation if I'm understanding right

 

[globalminds_ent 10+ year member]

Just get a splitter 2 male rca to 4 male rca run that to the 2 channel use the settings on the two channel to dial everything in