bgolightly82 10+ year member
Member
Can anybody help me with this? Not sure how to wire a set of 3ohm components. Was thinking about running 2 sets of the Soundstream SST's (3ohm). Can these be ran by 4ch @ 1 per channel?
How to 3 ohm components
- Thread starter bgolightly82
- Start date
- Replies 1
- Views 876
-
2Participant count
-
Participant list
Phoenix Risen 10+ year member
OG.... Original Ginger
as long as the amp is stable at 3 ohms youll be fine, most 4 chans are btw
Activity
No one is currently typing a reply...
Similar threads
The HU us likley 12-15 x 4 at best so yes, using an amp will be hugely beneficial, night and day. The HU us not going to drive a sub to any...
- Started by Paul Curtis
- General Car Audio
What is the impedance of each set of terminals,assuming they represent each of the two dual voice coil subs (4 coils total)?
How many sets of +/-...
- Started by tbcopeland1
- Wiring, Electrical & Installation
Not all chargers are the same and charge and different rates. Any battery will deplete in that type of weather if you do not crank the vehicle for...
- Started by Bluecarz77
- Amplifiers
FOR SALE
Taramps md3000.1 1 ohm new
Brand new
210 shipped
TECHNICAL INFORMATION
OPERATION CLASSClass D
NUMBER OF CHANNELS01
MAXIMUM POWER@ 12.6 VDC - 1 OHM: 3000W RMS
@ 12.6 VDC -...
- Started by mclerico1983
- Car Audio Classifieds
This is what I usually do before I put my main gear in. For my temp setups, Ill thrown in what I have close by out of my stash.
- Started by jeff47424
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 1
- Views
- 876
- Last reply date
- Last reply from
- Phoenix Risen
