Help wiring subs

[Mjp1531]

Hey guys. I have 2 audiobahn alum10q DVC that I'm going to run to a 2 channel pioneer gmx862. I know that I need a better amp, but for now it's all I have to work with. Money is too tight to spend on another one, and these will at least help boost some sound above stock. The amp specs say that it can handle 2 ohm if it isn't bridged. Other than that, the specs all point to 4 ohm being the best that the amp can do. The subs are 6 ohm each. What is the best wiring setup to give the most thump/power? I know a lot of it is up to how it sounds to me, but I'm trying to get a good place to start. Can anyone help? Do you have a picture to show me exactly where to put the wires? Thanks in advance for any help. Sorry for being such a noob

Click to read more...

 

[n2audio 5,000+ posts]

Wire them for 6, bridge the amp. You bridge the amp by connecting to the left (+) and right (-).

 

[Mjp1531]

Thank you ?