Help: Mini Setup using RF T400-4 to power components + a sub

[beyap 10+ year member]

RF T400-4

60W x 4 @ 4-Ohms RMS

100W x 4 @ 2-Ohms RMS

200W x 2 @ 4-Ohms bridged RMS

2-Ohms x 2 bridged Stable

Can i run this amp 4 ohms in the front then bridge the rear @ 2 ohms? Or will the amp either run all 4 ohms or all 2 ohms?

I have a kicker ds680.2 components (45W x2 @ 4 ohms) and am not sure what sub i need to to put on the back. I'm thinking RE SR10D2 (~300W RMS 2 ohms DVC) or JL 10W3V3-4 (~300W RMS, 4 ohms SVC), or would using either sub work fine?

Click to read more...

 

[Macklessdaddy 10+ year member]

it is 2 ohm stable bridged

 

[beyap 10+ year member]

it is 2 ohm stable bridged

I take that as a yes, I can run the fronts at 4 ohms then bridge a 4 ohms DVC sub for the rear? The amp should be set to 4 channel, right?

 

[Macklessdaddy 10+ year member]

I take that as a yes, I can run the fronts at 4 ohms then bridge a 4 ohms DVC sub for the rear? The amp should be set to 4 channel, right?

correctamundo

 

[beyap 10+ year member]

correctamundo

Thanks //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif