Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Help: Mini Setup using RF T400-4 to power components + a sub
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="beyap" data-source="post: 5018298" data-attributes="member: 569421"><p>RF T400-4</p><p></p><p>60W x 4 @ 4-Ohms RMS</p><p></p><p>100W x 4 @ 2-Ohms RMS</p><p></p><p>200W x 2 @ 4-Ohms bridged RMS</p><p></p><p>2-Ohms x 2 bridged Stable</p><p></p><p>Can i run this amp 4 ohms in the front then bridge the rear @ 2 ohms? Or will the amp either run all 4 ohms or all 2 ohms?</p><p></p><p>I have a kicker ds680.2 components (45W x2 @ 4 ohms) and am not sure what sub i need to to put on the back. I'm thinking RE SR10D2 (~300W RMS 2 ohms DVC) or JL 10W3V3-4 (~300W RMS, 4 ohms SVC), or would using either sub work fine?</p></blockquote><p></p>
[QUOTE="beyap, post: 5018298, member: 569421"] RF T400-4 60W x 4 @ 4-Ohms RMS 100W x 4 @ 2-Ohms RMS 200W x 2 @ 4-Ohms bridged RMS 2-Ohms x 2 bridged Stable Can i run this amp 4 ohms in the front then bridge the rear @ 2 ohms? Or will the amp either run all 4 ohms or all 2 ohms? I have a kicker ds680.2 components (45W x2 @ 4 ohms) and am not sure what sub i need to to put on the back. I'm thinking RE SR10D2 (~300W RMS 2 ohms DVC) or JL 10W3V3-4 (~300W RMS, 4 ohms SVC), or would using either sub work fine? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Help: Mini Setup using RF T400-4 to power components + a sub
Top
Menu
What's new
Forum list
